OIL SEED PROCESSING

Water assisted. Here the finely ground oilseed is either boiled in water and the oil that floats to the surface is skimmed off or ground kernels are mixed with water and squeezed and mixed by hand to release the oil. b) Manual pressing. Here oilseeds, usually pre-ground, are pressed in manual screw presses. A typical press is shown in diagram 1. c) Expelling. An expeller consists of a motor driven screw turning in a perforated cage. The screw pushes the material against a small outlet, the "choke". Great pressure is exerted on the oilseed fed through the machine to extract the oil. Expelling is a continuous method unlike the previous two batch systems. d) Ghanis. A ghani consists of a large pestle and mortar rotated either by animal power or by a motor. Seed is fed slowly into the mortar and the pressure exerted by the pestle breaks the cells and releases the oil. Ghani technology is mainly restricted to the Indian sub-continent. e) Solvent extraction. Oils from seeds or the cake remaining from expelling is extracted with solvents and the oil is recovered after distilling off the solvent under vacuum.
Most oil bearing seed need to be separated from outer husk or shell. This is referred to as shelling, hulling or decortication. Shelling increases the oil extraction efficiency and reduces wear in the expeller as the husks are abrasive. In general some 10% of husk is added back prior to expelling as the fibre allows the machine to grip or bite on the material. After decortication the shell may have to be separated from the kernels by winnowing. At small scale this can be done by throwing the material into the air and allowing the air to blow away the husk. At larger scale mechanical winnowers and seed cleaners are available
A wide range of makes and sizes of expellers are available. In India in particular a number of efficient small or "baby" expellers are available. A typical example with a capacity of up to 100 kg/hr is shown in figure.3. This machine has a central cylinder or cage fitted with eight separate sections or "worms". This flexible system allows single or double-reverse use and spreads wear more evenly along the screw. When the screw becomes worn only individual sections require repair thus reducing maintenance costs. As the material passes through the expeller the oil is squeezed out, exits through the perforated cage and is collected in a trough under the machine. The solid residue, oil cake, exits from the end of the expeller shaft where it is bagged.